Restoration Painting Dubai

Fix the wall first — then paint it properly

Cracks, damp stains, peeling and bubbling walls — we diagnose the cause, fix it properly, then repaint to a flawless finish that actually lasts.

Get Free Quote Call Now

Why restoration matters

Painting over problems doesn't solve them

The most common complaint we receive from customers who've hired other painters is that the new paint looked fine for a few months before the same cracks reappeared, the same patches bubbled or the same damp stains bled back through. The reason is almost always the same: the underlying problem wasn't addressed before painting — just covered over.

In Dubai specifically, wall damage often has identifiable root causes: hairline cracking from thermal expansion in extreme heat, salt crystallisation near coastal or ground-floor walls, moisture ingress from roof or window seal failures, and mould growth driven by the contrast between indoor air conditioning and outdoor humidity. Painting over any of these without treating the cause is a temporary fix at best.

Our restoration painting service starts with identifying the cause of the damage, recommending the appropriate fix, carrying out the repair work and then applying the right primer and paint system for the repaired surface. The result is a wall that looks new and stays that way.

🔨

Crack repair

Hairline to structural cracks filled with appropriate compounds, taped where necessary, allowed to cure, sanded flush and primed. Done properly so they don't reappear.

💧

Damp & water stains

Stain-blocking shellac or oil-based primer applied to damp and water-stained areas to prevent bleed-through. Damp-proof coatings for affected masonry.

🧹

Peeling paint removal

Complete removal of all loose and flaking paint by scraping, sanding and wire brushing before new primer is applied. Not just painted over.

🏗️

Skim coating

Full-wall skim coats where surfaces are rough, damaged or textured — resulting in a perfectly smooth, even surface for painting.

🔲

Gypsum board repair

Damaged gypsum (drywall) panels cut out, replaced and finished seamlessly so new paint shows no patch lines or edges.

🔵

Mould treatment

Anti-mould biocide wash, specialist mould-killing primer and mould-resistant topcoat for walls with recurring mould or humidity issues.

FAQ

Restoration painting Dubai — FAQ

Recurring cracks are usually caused by thermal movement — Dubai's extreme temperature swings cause masonry to expand and contract significantly, reopening any rigid crack filler. The solution is to use a flexible crack filler, tape hairline cracks with alkali-resistant mesh tape before filling, and apply an elastomeric primer that moves with the wall. We also check for structural causes like building settlement that may require a structural engineer's input.

Bubbling and peeling in Dubai is most commonly caused by moisture trapped behind the paint film — either from damp walls, condensation driven by air conditioning, or paint applied over a surface that wasn't fully dry. Other causes include painting over a glossy surface without sanding, incompatible paint systems or very cheap paint with low adhesion. We identify the specific cause before recommending and carrying out repairs.

We can eliminate existing mould and make recurrence much less likely — but if the underlying moisture source isn't addressed, mould will eventually return. Our treatment kills existing mould spores with a biocide wash, we apply a specialist mould-inhibiting primer and finish with mould-resistant topcoat. We also advise on ventilation and humidity control to help prevent recurrence.

This depends on the extent of damage. Minor crack filling and spot priming can be done same-day before painting. Full skim coating of a room requires the skim to dry for 24–48 hours before sanding and painting. Damp treatment requires identification of the moisture source and may require additional drying time before primers can be applied effectively.